Getting Started
Safety Warnings
Safety Warnings
WARNING Removing the device cover may expose sharp edges in the equipment chassis.
To avoid injury, use care when installing customer add-on devices.
NOTE Before performing removal/replacement procedures, position the workstation on a
cushioned flat, stable surface, such as a table top or workbench.
NOTE Installing the recommended HP replacement part in your B Class and C Class
workstation does not affect the regulatory and safety classifications or approvals listed
in the original owner’s guide.
Electrostatic Discharge (ESD) Precautions
To prevent damage to the B Class and C Class workstation, observe all of the following
ESD precautions while performing removal and replacement procedures:
• Remove all ESD-generating materials from the work area in which you will remove
and replace the workstation field replaceable unit(s).
• Open the ESD materials provided with the replacement part kit. Unfold the black
conductive sheeting (antistatic mat) and place it under a corner of the workstation.
• Wear a static strap to ensure that any accumulated electrostatic charge is
discharged from your body to ground. Attach the static-grounding wrist strap by
following the instructions on the package. Attach the sticky end of the wrist strap to
bare metal on the rear panel of the workstation.
• Connect all equipment together, including the static-free mat, static strap, clips
attached to the wrist strap, nodes, and peripheral units.
• Keep uninstalled printed circuit boards in their protective antistatic bags.
• Once you have removed printed circuit boards from their protective antistatic bags,
handle the printed circuit boards by their edges only.
2
Chapter 1
To Next Page
Loading...
Need help?
General