HP E3800 Series User Manual

6-59
RADIUS Authentication, Authorization, and Accounting
Accounting Services
Example. To configure RADIUS accounting on the switch with start-stop for
Exec functions, stop-only for system functions, and interim-update for com-
mands functions. This example continues from figure 6-21, where the session
ID was configured as common.
Figure 6-22. Example of Configuring Accounting Types and Controls
Syntax: [no] aaa accounting < exec | network | system > < start-stop | stop-only >
radius
[no] aaa accounting command < stop-only | interim-only > radius
Configures RADIUS accounting service type and how data will be
sent to the RADIUS server.
< exec | network | system | command >: Specifies an accounting
service type to configure. Refer to “Accounting Service
Types” on page 6-57.
start-stop: Applies to exec, network, and system
accounting service types. Refer to “Accounting
Controls” on page 6-58.
stop-only: Applies to all accounting service types.
Refer to “Accounting Controls” on page 6-58.
interim-update:
Applies to the commands accounting
service type. Refer to “Accounting Controls” on page
6-58.
HP Switch(config)# aaa accounting exec start-stop radius
HP Switch(config)# aaa accounting system stop-only radius
HP Switch(config)# aaa accounting commands interim-update radius
HP Switch(config)# show accounting
Status and Counters - Accounting Information
Interval(min) : 0
Suppress Empty User : No
Sessions Identification : Common
Type | Method Mode Server Group
-------- + ------ -------------- -------------
Network | None
Exec | Radius Start-Stop
System | Radius Stop-Only
Commands | Radius Interim-Update
Common is configured to apply the same
Acct-Session-ID to all accounting records
for a given switch management session.
Exec, System, and Commands accounting
are active. (Assumes the switch is
configured to access a reachable RADIUS
server.)

HP E3800 Series Specifications

General

Brand	HP
Model	E3800 Series
Category	Switch
Language	English