16-2
Key Management System
Configuring Key Chain Management
■ Time-Dependent key: a key that has an activate and deactivate time
associated with the Accept and Send processes. Time-Dependent
keys expire, which means a key chain is needed to keep the assigned
protocols supplied with keys.
■ Key Management System (KMS) Enabled Protocol: A protocol
that uses KMS to store authentication key information.
Configuring Key Chain Management
The Key Management System (KMS) has three configuration steps:
1. Create a key chain entry.
2. Assign a time-independent key or set of time-dependent keys to the Key
Chain entry. The choice of key type is based on the level of security
required for the protocol to which the key entry will be assigned.
3. Assign the key chain to a KMS-enabled protocol.
This procedure is protocol-dependent. For information on a specific protocol,
refer to the chapter covering that protocol in the Management and Configu-
ration Guide for your switch.
Creating and Deleting Key Chain Entries
To use the Key Management System (KMS), you must create one or more key
chain entries. An entry can be the pointer to a single time-independent key or
a chain of time-dependent keys.
Note The key chain information is copied to the standby management module (if
redundancy is enabled and the standby module has passed self-test).
KMS-Related CLI Commands in This Section Page
show key-chain < chain_name > page 16-2
[ no ] key-chain chain_name page 16-2
[ no ] key-chain chain_name key Key_ID page 16-3
To Next Page
Loading...
Need help?
General