To insert the battery, reverse the removal procedures.
Speakers
To remove the speakers, use this procedure and illustration.
Table 6-2 Speakers description and part number
Description Spare part number
Speakers M35259-001
Before removing the speakers, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 28).
2. Remove the pen (see Pen on page 28).
3. Remove the bottom cover (see Bottom cover on page 30).
4. Remove the battery (see Battery on page 31).
Remove the speakers:
1. Disconnect the right speaker cable from the system board (1).
NOTE: If tape is holding the cables in place, gently pull up and reuse the tape when reassembling the
speakers.
2. Remove the antenna cable from its routing path near the right speaker (2).
NOTE: You must pull the WWAN antenna cables and tape up and left before you can remove the left
speaker cable.
3. Disconnect the left speaker cable from the system board (3).
4. Remove the right speaker cable from the channel below the system board (4).
5. Remove the two Phillips M1.4 × 1.2 screw (5) from each speaker.
Component replacement procedures 33
To Next Page
Loading...
Need help?
General