ENWW HP Software Solutions Summary 18
HP Install Network Printer Wizard
(Windows)
The HP Install Network Printer Wizard, version 4.0 or above, is a
utility for printer setup and installation on a TCP/IP or IPX/SPX
network.
For wireless print servers, the wizard includes modules that allow
you to first configure wireless settings on the print server so that it
can connect to your network.
Once your printers have a network connection (either through a
cabled/wired connection or a wireless connection), the wizard
installs the printer on your systems or servers that will send print
jobs directly to the printer. This is called “direct-mode”, or
“peer-to-peer” printing.
If your system is a server, you can share the printer so that network
clients can use the printer through the server, also known as
“client-server” printing.
The HP Install Network Printer Wizard is included on the
HP Jetdirect CD-ROM supplied with standalone HP Jetdirect
products. The wizard is run through the Install selection on the
Jetdirect CD-ROM interface. The wizard runs from the CD-ROM,
although some files may be temporarily stored and then removed
from your system disk after a system reboot.
A version that runs from your system disk is also available and can
be downloaded from HP online support at:
http://www.hp.com/go/inpw_sw
Requirements
● Microsoft Windows XP, Windows 2000, Windows NT 4.0,
Windows 98/Me, Server 2003
◆ TCP/IP or IPX/SPX network protocol
To Next Page
Loading...
Need help?
General
