ENWW TCP/IP Configuration 40
Using BOOTP/TFTP
Note For HP Jetdirect wireless print servers, this section
assumes that a wireless connection to your network
has been established.
BOOTP (Bootstrap Protocol) and TFTP (Trivial File Transfer
Protocol) provide a convenient way to automatically configure the
HP Jetdirect print server for TCP/IP network operation. When
powered on, the Jetdirect print server sends a BOOTP request
message onto the network. A properly configured BOOTP server
on the network will respond with a message that contains basic
network configuration data for the Jetdirect print server. The
BOOTP server’s response may also identify a file that contains
extended configuration data for the print server. The Jetdirect print
server downloads this file using TFTP. This TFTP configuration file
may be located on the BOOTP server, or a separate TFTP server.
BOOTP/TFTP servers are typically UNIX or Linux systems.
Windows NT/2000/Server 2003 and NetWare servers can respond
to BOOTP requests. Windows NT/2000/Server 2003 servers are
configured through Microsoft DHCP services (see Using DHCP
).
However, Windows NT/2000/Server 2003 systems may require
third-party software for TFTP support. For setup of NetWare
BOOTP servers, refer to your NetWare documentation.
Note If the Jetdirect print server and BOOTP/DHCP
server are located on different subnets, IP
configuration may fail unless the routing device
supports “BOOTP Relay” (allows the transfer of
BOOTP requests between subnets).
To Next Page
Loading...
Need help?
General
