ENWW Troubleshooting the HP Jetdirect Print Server 186
Resetting to Factory Defaults
Parameters on the HP Jetdirect print server (for example, the
IP address) can be reset to factory default values using the following
procedures:
CAUTION For HP Jetdirect wireless print servers, resetting to
factory default settings may cause the print server
to lose its wireless connection to your network.
Reconfiguration of wireless network settings and
reinstallation of the print server may be required.
A Jetdirect X.509 certificate will be saved over a cold
reset to factory default values. However, a
Certificate Authority (CA) certificate installed to
validate a network authentication server will not be
saved.
● HP LaserJet Printer with Internal EIO Print Server
In most cases, the HP Jetdirect internal print server can be reset
to factory defaults when a cold-reset is performed on the printer.
CAUTION Resetting the printer will reset all printer settings
to their factory defaults. After resetting the printer,
you may need to use the printer's control panel to
reconfigure printer settings that are required by
users.
■ For older HP LaserJet printers, a cold-reset is performed by
power cycling the printer while pressing the Go, Start, or
Pause/Resume button.
■ For recent LaserJet printers and MFPs, use the Menu,
Configure Device, Resets menu at the control panel.
■ For other printers, refer to your printer manuals. Or, visit
http://www.hp.com/go/support
and search for document file
bpj02300.html.
To Next Page
Loading...
Need help?
General
