ENWW Troubleshooting the HP Jetdirect Print Server 200
Troubleshooting an LPD UNIX
Configuration
Note For HP Jetdirect wireless print servers, this section
assumes that a wireless connection to your network
has been established.
The troubleshooting steps below describe how to troubleshoot
printing problems you may have with the HP Jetdirect print server.
1. Print a Jetdirect configuration page.
2. Verify that the IP configuration values are correct. If they are
not, reconfigure the HP Jetdirect print server.
3. Log onto the host system and type:
ping <IP address>
where <IP address> is the IP Address assigned to the printer.
4. If ping fails, make sure the IP Address on the configuration page
is correct. If it is correct, the problem is in the network.
5. If the ping test passes, print a test file. At the UNIX prompt,
type:
lpr -Pprinter_name test_file (BSD-based and Linux
systems)
where printer_name is the name of your printer and
test_file is an appropriate file (ASCII, PCL, PostScript,
HP-GL/2, or text) for the printer defined in the :rp tag in the
printcap file.
6. If the test file does not print, do the following:
■ Check printcap entries.
■ Check printer status (using LPC or a similar process).
■ Examine the contents of the logfile for this printer, such as
/usr/spool/lpd/error_log_filename
■ Check other log files, such as
HP-UX: /usr/adm/syslog
To Next Page
Loading...
Need help?
General
