EasyManuals Logo
Home>HP>Switch>FlexNetwork 5140 EI Series

HP FlexNetwork 5140 EI Series User Manual

HP FlexNetwork 5140 EI Series
66 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #21 background imageLoading...
Page #21 background image
17
Installing a power supply
1. Wear an ESD wrist strap and make sure it makes good skin contact and is reliably grounded.
2. Unpack the power supply and verify that the power supply model is as required.
3. Remove the filler panel (if any) from the target slot.
If you require only one power supply, install it in power supply slot 1 and make sure a filler panel
is installed in power supply slot 2.
4. Orient the power supply with the upside up. Grasp the handle of the power supply with one
hand and support its bottom with the other, and slide the power supply slowly along the guide
rails into the slot. See callout 1 in Figure 19.
To prevent damage to the power supply and the connector on the switch backplane, insert the
power supply gently. If you encounter a hard resistance or the power supply tilts while inserting
the power supply, pull out the power supply, realign it with the slot, and then insert it again.
5. Fasten the captive screws on the power supply with a Phillips screwdriver to secure the power
supply in the chassis. See callout 2 in Figure 19.
If the captive screw cannot be tightly fastened, examine the installation of the power supply.
Figure 19 Installing a power supply
Removing a power supply
1. Wear an ESD wrist strap and make sure it makes good skin contact and is reliably grounded.
2. Power off the power supply and remove the power cord.
3. Loosen the captive screws on the power supply with a Phillips screwdriver until they are
completely disengaged from the chassis.
4. Grasp the handle of the power supply with one hand and pull the module part way out. Support
the module bottom with the other hand, and pull the power supply slowly along the guide rails
out of the slot.
5. Place the removed power supply in an antistatic bag.
1
2
2

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP FlexNetwork 5140 EI Series and is the answer not in the manual?

HP FlexNetwork 5140 EI Series Specifications

General IconGeneral
BrandHP
ModelFlexNetwork 5140 EI Series
CategorySwitch
LanguageEnglish

Related product manuals