A
amber52Aug 7, 2025
What to do if there is no display on the HP FlexNetwork 5140 EI configuration terminal?
- AalvarezbillyAug 7, 2025
If there's no display on the configuration terminal of your HP Switch, check the following: * Ensure the power system is working correctly. * Confirm the switch itself is operating as expected. * Verify the console cable is properly connected. * Check that the terminal settings are: Baud rate—9600, Data bits—8, Parity—None, Stop bits—1, Flow control—None. * Make sure the console cable isn't faulty.