To Next Page

To Previous Page

4-27

Web and MAC Authentication

Configuring Web Authentication

Figure 4-8. Example of show port-access web-based Command Output

Figure 4-9. Example of show port-access web-based clients Command Output

HP Switch(config)# show port-access web-based

Port Access Web-Based Status

Auth Unauth Untagged Tagged Port % In RADIUS

Port Clients Clients VLAN VLANs COS Limit ACL

----- -------- -------- -------- ------ -------- ------ ------

1 1 1 4006 Yes 70000000 100 Yes

2 2 0 MACbased No Yes Yes Yes

3 4 0 1 Yes No No No

Syntax: show port-access web-based clients [port-list]

Displays the session status, name, and address for each web-

authenticated client on the switch. The IP address displayed

is taken from the DHCP binding table (learned through the

DHCP Snooping feature).

If DHCP snooping is not enabled on the switch, n/a (not

available) is displayed for a client’s IP address.

If a web-authenticated client uses an IPv6 address, n/a - IPv6

is displayed.

If DHCP snooping is enabled but no MAC-to-IP address

binding for a client is found in the DHCP binding table, n/a

- no info is displayed.

HP Switch(config)# show port-access web-based clients

Port Access Web-Based Client Status

Port Client Name MAC Address IP Address Session Status

----- ------------ ------------- --------------- -------------

1 webuser1 0010b5-891a9e 192.192.192.192 Authenticated

1 webuser2 001560-b3ea48 n/a - no info Authenticating

1 webuser3 000000-111111 n/a - IPv6 Authenticating

3 webuser4 000000-111112 n/a Authenticating

HP J8697A User Manual

Other manuals for HP J8697A