10-98
IPv4 Access Control Lists (ACLs)
Displaying ACL Configuration Data
Display an ACL Summary
This command lists the configured IPv4 and IPv6 ACLs, regardless of whether
they are assigned to any VLANs.
For example:
Figure 10-32. Example of a Summary Table of Access lists
Syntax: show access-list
List a summary table of the name, type, and application status
of IPv4 and IPv6 ACLs configured on the switch.
Term Meaning
Type Shows whether the listed ACL is an IPv4
std ACL, an IPv4 ext ACL, or an IPv6 ACL.
Appl Shows whether the listed ACL has been applied to an interface (
yes/no).
Name Shows the identifier (name or number) assigned to each ACL configured in the switch.
HP Switch(config)# show access-list
Access Control Lists
Type Appl Name
---- ---- ------------------------------------------
ext yes 101
std yes 55
ext yes Marketing
ipv6 no Accounting
ipv6 no List-01-Inbound
ipv6 yes List-02-Outbound
ipv6 yes Test-1
These ACLs exist in the
configuration but are not
applied to any interfaces and
thus do not affect traffic.
IPv4 ACLs
To Next Page
Loading...
Need help?
General
