10-103
IPv4 Access Control Lists (ACLs)
Displaying ACL Configuration Data
Displaying the Content of a Specific ACL
This command displays a specific IPv6 or IPv4 ACL configured in the running
config file in an easy-to-read tabular format.
Note This information also appears in the show running display. If you execute write
memory after configuring an ACL, it also appears in the show config display.
For information on IPv4 ACL operation, refer to the latest version of the Access
Security Guide for your switch.
For example, suppose you configured the following two ACLs in the switch:
Use show access-list < identifier > to inspect a specific IPv6 or IPv4 ACL, as
follows:
Syntax: show access-list < identifier > [config]
Display detailed information on the content of a specific ACL
configured in the running-config file.
Identifier Ty pe Desired Action
Accounting IPv6 • Permit Telnet traffic from these two IPv6 addresses:
– 2001:db8:0:1af::10: 14
– 2001:db8:0:1af::10: 24
• Deny Telnet traffic from all other devices in the same subnet.
• Permit all other IPv6 traffic from the subnet.
• Deny and log any IPv6 traffic from any other source.
List-120 IPv4
Extended
• Permit any TCP traffic from 10.30.133.27 to any destination.
• Deny any other IPv4 traffic from 10.30.133.(1-255).
• Permit all other IPv4 traffic from any source to any destination.
To Next Page
Loading...
Need help?
General
