Port Status and Basic Configuration
Viewing Port Status and Configuring Port Parameters
Figure 10-2. Example of Port/Trunk Settings with a Trunk Group Configured
2. Press [E] (for E
dit). The cursor moves to the Enabled field for the first port.
3. Refer to the online help provided with this screen for further information
on configuration options for these features.
4. When you have finished making changes to the above parameters, press
[Enter], then press [S] (for Save).
CLI: Viewing Port Status and Configuring Port
Parameters
Port Status and Configuration Commands
show interfaces brief below
show interfaces config page 10-9
interface page 10-10
show spanning tree page 10-10
show tech transceivers page 10-15
From the CLI, you can configure and view all port parameter settings and view
all port status indicators.
Using the CLI To View Port Status
Use the following commands to display port status and configuration:
â– show interfaces brief: Lists the full status and configuration for all ports
on the switch.
10-8
To Next Page
Loading...
Need help?
General