IP Routing Features
Configuring OSPF
Displaying OSFPF Redistribution Information
As described under “Enabling Route Redistribution” on page 11-50, you can
configure the routing switch to redistribute connected and static routes into
OSPF. When you redistribute a route into OSPF, the routing switch can use
OSPF to advertise the route to its OSPF neighbors.
To display the status of the OSPF redistribution, enter show ip ospf redistribute
at any CLI context level:
HPswitch# show ip ospf redistribute
OSPF redistributing
Route type Status
---------- --------
connected enabled
static enabled
Figure 11-19.Example of Output for Show IP OSPF Redistribute
The display shows whether redistribution of each of the route types,
connected and static is enabled.
Displaying OSFPF Redistribution Filter (restrict)
Information
As described under “Defining Redistribution Filters” on page 11-48, you can
configure the redistribution filters on the routing switch to restrict route
redistribution by OSPF.
To display the status of the OSPF redistribution filters, enter show ip ospf
restrict at any CLI context level.
HPswitch# show ip ospf restrict
OSPF restrict list
IP Address Mask
--------------- ---------------
10.0.8.0 255.255.248.0
15.0.0.0 255.0.0.0
Figure 11-20.Example of Output for Show IP OSPF Restrict
11-64
To Next Page
Loading...
Need help?
General