2-9
Installing the Switch 408
Installation Procedures
4. Connect the Switch to a Power Source
1. Plug the included AC power adapter into the switch’s power
connector and into a nearby AC power source.
2. Re-check the LEDs during self test. See “LED Behavior” on
page 2-7.
5. Connect the Network Cables
Using the RJ-45 Connectors (10/100Base-TX ports)
To connect:
Push the RJ-45 plug into the
RJ-45 jack until the tab on
the plug clicks into place.
When power is on for the
switch and for the connected
device, the Link/Act LED for
the port should light to
confirm a powered-on
device (for example, an end
node) is at the other end of
the cable.
If the Link LED does not go
on when the network cable is
connected to the port, see
“Diagnosing With the LEDs”
in chapter 3, “Trouble-
shooting”.
To disconnect:
Press the small tab on the plug and pull the plug out of the jack.
RJ-45 connector
100-ohm unshielded or shielded
twisted-pair cable:
• Category 3, 4, or 5 for 10 Mbps ports
• Category 5 only for 100 Mbps ports
Maximum distance: 100 meters
To Next Page
Loading...
Need help?
General