Introduction
Context hierarchy
1-7
Context hierarchy
CLI commands are grouped into functional contexts. The following table shows the context
hierarchy and the command used to switch from the parent context.
Sample CLI session
This sample CLI session shows you how to set the wireless port to support 802.11a on
channel 60 with medium distance between access points. (The CLI prompt is shown in bold.)
CLI> enable
CLI# config
CLI(config)# interface wireless
CLI(config-if-wlan)# dot11 a 60
CLI(config-if-wlan)# distance medium
CLI(config-if-wlan)# end
CLI(config)# end
CLI# quit
Context hierarchy Command to switch from parent context
View context (This is the root context. No command is needed.)
Enable context enable
Config context config
WAN IP interface context interface ip
Port-2 interface context interface ethernet port-2
VLAN interface context interface vlan <id>[-<id2>]
Port-1 interface context interface ethernet port-1
VLAN interface context interface vlan <id>[-<id2>]
Wireless context interface wireless <number>
Local mesh context local mesh profile <name>
VLAN interface context interface vlan <number>
GRE interface context interface gre <name>
Virtual AP context virtual ap <name>
Syslog destination context logging destination <name>
SNMP user context snmp-server user <name>
SNMP notification receiver context snmp-server notification receiver <host>
RADIUS context radius-server profile <name>
IP_QOS context ip-qos profile <name>
Network profile context network-profile <name>
To Next Page
Loading...
Need help?
General
