HP ProCurve MSM310 Reference Guide

CLI commands
Wireless context
2-55
Use this parameter to adjust the receiver sensitivity of the AP. This parameter should only be
changed if:
 you have more than one wireless access point installed in your location
 you are experiencing throughput problems
In all other cases, use the default setting of Large.
If you have installed multiple APs, reducing the receiver sensitivity of the AP from its maximum
will help to reduce the amount of crosstalk between the wireless stations to better support
roaming clients. By reducing the receiver sensitivity, client stations will be more likely to connect
with the nearest access point.
dot11
Supported on: MSM422 MSM320 MSM410 MSM310 MSM335
dot11 <mode> <frequency>
Sets the wireless mode and the frequency the AP will operate at.
Parameters
<mode> Sets the transmission speed and frequency band. The available options are
determined by the wireless card installed in the AP, and may include:
a: Selects 802.11a providing 54 Mbps in the 5 GHz frequency band.
b: Selects 802.11b providing 11 Mbps in the 2.4 GHz frequency band.
g: Selects 802.11g providing 54 Mbps in the 2.4 GHz frequency band.
bg: Selects 802.11b + 802.11g providing 11 and 54 Mbps in the 2.4 GHz
frequency band.
n: Selects 802.11n.
an: Selects 802.11n + 802.11a, on the 5Ghz frequency band.
gn: Selects 802.11n + 802.11g, on the 2.4Ghz frequency band.
bgn: Selects 802.11n + 802.11g + 802.11b, on the 2.4Ghz frequency band.
<frequency> Sets the operating frequency by specifying a number in GHz or by
specifying a channel number. The frequencies that are available are
determined by the radio installed in the AP and the regulations that apply
in your country.
For optimum performance when operating in 802.11b or 802.11g modes,
choose a frequency that differs from other wireless access points operating
in neighboring cells by at least 25 MHz.
If operating in 802.11a mode, all channels are non-overlapping.
transmit power
Supported on: MSM422 MSM320 MSM410 MSM310 MSM335
transmit power (DB | max)
Sets the maximum transmission power of the wireless radio.
Parameters
<db> Power is specified in steps of 1dBm. The maximum setting is 18 dBm.
Note: The actual transmit power used may less than the value specified. The AP determines the
power to used based on the settings you made for regulatory domain, wireless mode, and
operating frequency.

HP ProCurve MSM310 Specifications

General

Brand	HP
Model	ProCurve MSM310
Category	Wireless Access Point
Language	English