CLI commands
Config context
2-38
New lldp dynamic-name refresh-time
Supported on: MSM422 MSM320 MSM410 MSM310 MSM335
lldp dynamic-name refresh-time <time>
Sets the interval at which dynamic names for controlled APs are updated.
New lldp dynamic-name user-string
Supported on: MSM422 MSM320 MSM410 MSM310 MSM335
lldp dynamic-name user-string <name>
Specifies the text to use for the dynamic name.
You can use regular text in combination with placeholders to create the name. Placeholders are
automatically expanded each time the name is regenerated.
Placeholders
%RN System name of the neighboring device to which the port is connected,
obtained via the System Name TLV. Since this is an optional TLV, if it is not
available, the Chassis ID TLV is used instead.
%RP Port description of the port on the neighboring device to which the local
port is connected, obtained via the Port Description TLV. Since this is an
optional TLV, if it is not available, the Port ID TLV is used instead.
%SN Controller’s serial number.
%IP Controller’s IP address. An IP address can require up to 15 characters
(nnn.nnn.nnn.nnn).
New lldp fast-start-count
Supported on: MSM422 MSM320 MSM410 MSM310 MSM335
lldp fast-start-count <count>
After an MED LLDPDU is received, this timer is started and the agent sends one MED LLDPDU to
the MED device each second as it counts down.
New lldp holdtime-multiplier
Supported on: MSM422 MSM320 MSM410 MSM310 MSM335
lldp holdtime-multiplier <hold>
Sets the hold time multiplier for LLDPDU transmissions.
The value of Multiplier is multiplied by the refresh-interval to define Time to live. Time to live
indicates the length of time that neighbors will consider LLDP information sent by this agent to be
valid.
New lldp med-location civic-address-element
Supported on: MSM422 MSM320 MSM410 MSM310 MSM335
lldp med-location civic-address-element <caelement>
Adds a Civic Address Element.
To Next Page
Loading...
Need help?
General
