HP ProLiant DL360 G7 User Manual

Setup 32
Installing the operating system
To operate properly, the server must have a supported operating system. For the latest information on
supported operating systems, refer to the HP website (http://www.hp.com/go/supportos
).
Two methods are available to install an operating system on the server:
• SmartStart assisted installation—Insert the SmartStart CD into the CD-ROM drive and reboot the
server.
• Manual installation—Insert the operating system CD into the CD-ROM drive and reboot the server.
This process may require you to obtain additional drivers from the HP website
(http://www.hp.com/support
).
Follow the on-screen instructions to begin the installation process.
For information on using these installation paths, refer to the SmartStart installation poster in the HP
ProLiant Essentials Foundation Pack, included with the server.
Registering the server
To register the server, refer to the HP Registration website (http://register.hp.com).

HP ProLiant DL360 G7 Specifications

General

Storage	Up to 8 SFF SAS/SATA/SSD drives
Form Factor	1U Rack
Processor	Intel Xeon 5600 series
Memory	Up to 192GB DDR3
Network	Embedded NC382i Dual Port Multifunction Gigabit Server Adapter
Power Supply	Hot-plug redundant power supplies (460W, 750W, or 1200W)
Expansion Slots	2 x PCIe Gen2
RAID Controller	HP Smart Array P410i
Network Controller	HP NC382i Dual Port Multifunction Gigabit Server Adapter
Management	Integrated Lights-Out 3 (iLO 3)
Operating System Support	Microsoft Windows Server, Red Hat Enterprise Linux, SUSE Linux Enterprise Server, VMware