Hardware options installation 63
Removable media device options
Identifying guide screws
When installing drives in the removable media bay, guide screws must be installed to make sure the drives
align correctly in the drive cage. HP has provided extra guide screws, 5.25 M3 metric screws and/or HD
6-32 shipping screws, located behind the media bay blank. The metric screws are black.
Installing a half-height or full-height media device
The server includes five removable media bays. The server ships with an optical drive, and the other four
bays have blanks. You can install two full-height devices or up to four additional half-height media devices in
the removable media cage.
To install a half-height or full-height media device:
1. Power down the server (on page 24).
2. Do one of the following:
o Open or remove the tower bezel, as needed ("Open or remove the tower bezel" on page 25).
o Extend the server from the rack (on page 24).
3. Remove the access panel (on page 26).
4. Remove the media bay blank (on page 27).
5. Install the guide screws ("Identifying guide screws" on page 63), if applicable.
6. Slide the drive about three-fourths of the way into the bay, leaving room to connect cables at the back
of the drive.
o Half-height device
To Next Page
Loading...
Need help?
General