Computer Setup—Power
NOTE: Support for specific Computer Setup options may vary depending on the hardware
configuration.
Table 3-5 Computer Setup—Power
Option Description
Hardware Power
Management
● SATA Power Management—Enables or disables the SATA bus and/or device power
management. Default is enabled.
●
S5 Maximum Power Savings—Turns off power to all nonessential hardware when system is
off to meet EUP Lot 6 requirement of less than 1 Watt power usage. Enabling this feature will
disable any wake events and management devices while in S5. Default is disabled.
●
S5 Wake on LAN—Enables or disables remotely waking up the computer from S5 (power is
off) power state. Default is disabled.
Disabling this feature obtains the lowest power consumption available on the computer
during S5. It does not affect the ability of the computer to Wake on LAN from suspend or
hibernation, but will prevent it from waking from S5 via the network. It does not affect
operation of the network connection while the computer is on.
If a network connection is not required, completely disable the network controller (NIC) by
using the arrow (left and right) keys to select the Security > Device Security menu. Set the
Network Controller option to Device Hidden. This prevents the network controller from
being used by the operating system and reduces the power used by the computer in S5.
Thermal Displays the CPU fan speed and system fan speed (RPMs).
Computer Setup (F10) Utilities 15
To Next Page
Loading...
Need help?
General