Rear panels
The rear panels are located above the stand. You must remove them to access internal components.
Although the following procedure shows only removing one panel, the procedure is the same for both
panels.
To remove the rear panels:
1. Prepare the computer for disassembly (see
Preparing to disassemble the computer on page 33).
2. Remove the small center panel below the rear ports by pulling out the top of the panel (1) then
lifting the panel off the computer (2).
Figure 7-15 Removing the center panel
46 Chapter 7 Removal and Replacement Procedures
To Next Page
Loading...
Need help?
General