Installing a liquid cooling solution
1. Disconnect power from the system (Predisassembly procedures on page 69),
2. Remove the side access panel (see
Removing the side access panel on page 72).
3. If your system has an airflow guide, remove it (see
Removing the airflow guide on page 92).
4. Remove the rear system fan assembly from the chassis (see
Removing the rear system fan
assembly on page 91).
5. Install the rear system fan in the LCS radiator fan holder. Place the edge of the fan in the holder,
and then rotate it into the holder until it snaps into place as shown in the following figure.
TIP: Ensure that the fan cable is positioned in the slot in the lower-right corner of the LCS radiator
fan holder.
Figure 5-56 Installing the system fan in the LCS radiator fan holder
6. Remove the CPU heatsink (see Removing the CPU heatsink on page 127).
ENWW Removing and installing components 119
To Next Page
Loading...
Need help?
General