Workstation speaker
This section describes how to remove and install the workstation speaker.
Removing the workstation speaker
To remove the workstation speaker:
1. Power down the workstation (see
Predisassembly procedures on page 69).
2. Disconnect power from the workstation (see
Predisassembly procedures on page 69).
3. Remove the side access panel (see
Removing the side access panel on page 72).
4. Remove the front bezel (see
Removing the front bezel on page 75).
5. Disconnect the speaker cable from the system board
as shown in the figure below.
6. Remove the two screws as shown
2
.
7. Slide the speaker away from the chassis and remove it from the chassis
.
Figure 5-22 Removing the workstation speaker
Installing the workstation speaker
To install the speaker, reverse the previous steps.
88 Chapter 5 Replacing components ENWW
To Next Page
Loading...
Need help?
General