5.8.2 Connecting Cables to a Mouse, Keyboard, and VGA Port
The front and rear panels of the server have DB15 VGA ports but no standard PS/2
port for a keyboard or mouse.
Connect a keyboard or mouse to a USB port on the front or rear panel if needed,
either directly or with a USB-to-PS/2 cable.
Step 1 Wear an ESD wrist strap. For details, see 5.3 ESD Protection.
Step 2 Plug the USB connector on the PS/2 cable into the USB port on the front or rear
panel of the server.
Step 3 Connect the connectors on the other end of the PS/2 cable to the keyboard and
mouse.
Step 4 Connect the DB15 connector on the VGA cable to the VGA port on the front or
rear panel of the server and tighten the two screws.
Step 5 Connect the other end of the VGA cable to the VGA port on the monitor and
tighten the two screws.
Figure 5-16 Connecting PS/2 and VGA cables
----End
5.8.3 Connecting a Network Cable
Before connecting or replacing a network cable, use a network cable tester to
check whether the new network cable is functional.
The new and old cables must be of the same model or be compatible.
Before installing a network cable to a network port, check that the network cable
connector is intact and the pins have no sundries or deformation.
Step 1 Wear an ESD wrist strap. For details, see 5.3 ESD Protection.
Step 2 Check the model of the new network cable.
TaiShan 200 Server
User Guide (Model 2280) 5 Install and Congure
Issue 04 (2020-01-16) Copyright © Huawei Technologies Co., Ltd. 57
To Next Page
Loading...
Need help?
General