6.1 Answering an Incoming Call and Exiting a Conference
You can specify how your TE30 handles incoming calls. You can also exit a conference anytime.
Answering an Incoming Call
Depending on your configuration, your TE30 automatically answers a call or prompts you to
answer a call manually:
l If you set Answer Mode to Answer call automatically and the TE30 is not in use during
a conference, the TE30 automatically answers the call.
l If you set Answer Mode to Manual, your TE30 prompts you to handle the call. You can
then use the remote control to answer or reject the call.
NOTE
To set the answer mode, choose Advanced Settings > Settings > Conference > Normal.
Exiting a Conference
When you are in a conference, you can exit by disconnecting your site from the conference.
Step 1 Press
on the remote control.
Step 2 When prompted, select OK.
----End
6.2 Setting Conference Parameters
Your TE30 is ready for videoconferencing using its default conference settings, but you can
customize these conference settings based on the site requirements.
Background
General conference parameters apply to the following conferences:
l Point-to-point conferences initiated by your site
l Multipoint conferences initiated by your site
l Conferences that your site joins by answering a call from a remote site
To initiate an H.239 dual stream conference, set the video and H.239 parameters. To initiate a
single stream conference, just set the video parameters. For details about the H.239 dual stream
mode, see 6.4 Sharing a Presentation.
Setting General Conference Parameters
Step 1 Choose Advanced Settings > Settings > Conference > Normal. Set the general conference
parameters by referring to Table 6-1.
HUAWEI TE30 Videoconferencing Endpoint
User Guide 6 Conference
Issue 01 (2013-03-27) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
45
To Next Page
Loading...
Need help?
General
