Hypertherm Powermax105 User Manual

Maintenance and RepaiR
Powermax105 Operator Manual 8-3
Part Inspect Action
Shield or
deflector
The center hole for roundness. Replace the shield if the hole is no longer
round.
The gap between the shield and the
nozzle for accumulated debris.
Remove the shield and clean away any
material.
Nozzle The center hole for roundness. Replace nozzle if the center hole is not
round.
Good Worn
Electrode
Max. 1.6 mm (1/16 in.)
Replace electrode if the surface is worn
or the pit depth is greater than 1.6 mm
(1/16 inch) deep.
Swirl ring The surface inside the swirl ring for
damage or wear and the gas holes
for blockages.
Replace swirl ring if the surface is
damaged or worn or any of the gas holes
are blocked.
Torch O-ring The surface for damage, wear, or a
lack of lubrication.
If the O-ring is dry, lubricate it and the
threads with a thin layer of silicone
lubricant. If the O-ring is worn or
damaged, replace it (058519).
Inspect the consumables

Hypertherm Powermax105 Specifications

General

Brand	Hypertherm
Model	Powermax105
Category	Welding System
Language	English