1-10 Powermax105 Operator Manual
Powermax105 cutting specifications
Handheld cut capacity (material thickness)
Recommended cut capacity at 500 mm/min (20 ipm)* 32 mm (1-1/4 in.)
Recommended cut capacity at 250 mm/min (10 ipm)* 38 mm (1-1/2 in.)
Severance capacity at 125 mm/min (5 ipm)* 50 mm (2 in.)
Pierce capacity (material thickness)
Pierce capacity for handheld cutting, or mechanized
cutting with programmable torch height control
22 mm (7/8 in.)
Pierce capacity for mechanized cutting without
programmable torch height control
20 mm (3/4 in.)
Maximum cut speed** (mild steel)
6 mm (1/4 in.) 5600 mm/min (220 ipm)
12 mm (1/2 in.) 2400 mm/min (95 ipm)
20 mm (3/4 in.) 1300 mm/min (50 ipm)
25 mm (1 in.) 760 mm/min (30 ipm)
32 mm (1-1/4 in.) 510 mm/min (20 ipm)
Gouging capacity
Metal removal rate on mild steel (65 A) 4.8 kg/hr (10.7 lbs/hr)
Metal removal rate on mild steel (85 A) 8.8 kg/hr (19.5 lbs/hr)
Metal removal rate on mild steel (105 A) 9.8 kg/hr (21.7 lbs/hr)
Duramax series torch weights (refer to page 1-5 Component weights (105 A
systems)] )
Duty cycle and voltage information (refer to page 1-6 Powermax105 power
supply ratings)
* Cut capacity speeds are not necessarily maximum speeds. They are the speeds that must be achieved to be rated at
that thickness.
** Maximum cut speeds are the results of Hypertherm’s laboratory testing. Actual cutting speeds may vary based on
different cutting applications.
To Next Page
Loading...
Need help?
General
