Hypertherm Powermax30 XP Service Manual

90 Powermax30 XP Service Manual 808150 Revision 0
6 – Power Supply Component Replacement
Replacing the component barrier
Remove the component barrier
1. Set the power switch to OFF (O), disconnect the power cord from the power source, and disconnect the gas supply.
2. Remove the component barrier from the power board side of the power supply. The barrier is flexible and can be bent
slightly for removal.
Figure 26
Kit number Description
228104 Kit: Component barrier
Component barrier

Hypertherm Powermax30 XP Specifications

General

Brand	Hypertherm
Model	Powermax30 XP
Category	Welding System
Language	English