2
DRIVING YOUR HYUNDAI
4
KEY POSITIONS
!
NOTE:
Do not hold the key in the "START"
position for more than 15 seconds.
o "ON"
When the key is at the "ON" position,
the ignition and all accessories are
available for use. If the engine is not
running, the key should not be left at
this position since the battery will be-
come discharged and damage to the
ignition system may also result. For
information regarding engine starting,
refer to "STARTING THE ENGINE".
o "ACC"
When the ignition key is at the "ACC"
position, the radio and other accesso-
ries may be used.
o "LOCK"
The ignition key may only be inserted or
removed at this position.
SC050A2-E
WARNING:
The engine must never be turned off
and the key removed from the igni-
tion key cylinder whilst the vehicle is
in motion since the steering lock will
operate and control of the vehicle
will be lost.
C040A01E
LOCK
ACC
ON
START
o "START"
The engine is started in this position. It
will crank until you release the key.
YC030A2-E
STEERING WHEEL LOCK
When the ignition key is removed, the
steering wheel lock will be activated.
The lock only engages at one position
of the steering wheel and therefore it will
be necessary to turn the wheel until this
position is reached. It is not, however,
necessary for the lock to be engaged
before leaving the vehicle since in the
event of attempted unauthorised re-
moval, the lock will engage when at-
tempts are made to steer the vehicle.
NOTE:
If difficulty is experienced in turning
the ignition key to the START posi-
tion, turn the steering wheel right
and left to release the tension and
then turn the key.
!
CAUTION:
Never remove the key from the igni-
tion lock whilst the vehicle is in
motion since the steering mecha-
nism lock will be activated.
To Next Page
Loading...
Need help?
General
