Electronic emission notices
This section contains the electronic emission notices or statements for the United States and other
countries.
Federal Communications Commission Statement
This explains the Federal Communications Commission's (FCC’s) statement.
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, might cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference, in which case the user will be
required to correct the interference at his own expense.
Properly shielded and grounded cables and connectors must be used in order to meet FCC emission
limits. IBM is not responsible for any radio or television interference caused by using other than
recommended cables and connectors, or by unauthorized changes or modications to this equipment.
Unauthorized changes or modications could void the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device might not cause harmful interference, and (2) this device must accept any interference
received, including interference that might cause undesired operation.
Industry Canada Compliance Statement
This Class A digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe A est conform à la norme NMB-003 du Canada.
Australia and New Zealand Class A Statement
Attention:
This is a Class A product. In a domestic environment this product might cause radio
interference in which case the user might be required to take adequate measures.
European Union Electromagnetic Compatibility Directive
This product is in conformity with the protection requirements of European Union (EU) Council Directive
2004/108/EC on the approximation of the laws of the Member States relating to electromagnetic
compatibility. IBM cannot accept responsibility for any failure to satisfy the protection requirements
resulting from a non-recommended modication of the product, including the tting of non-IBM option
cards.
Attention:
This is an EN 55022 Class A product. In a domestic environment this product might
cause radio interference in which case the user might be required to take adequate measures.
Responsible Manufacturer:
International Business Machines Corp.
New Orchard Road
Armonk, New York 10504
914-499-1900
European community contact:
IBM Deutschland GmbH Technical Regulations, Department M372 IBM-Allee 1, 71139 Ehningen,
Germany Tele: +49 7032 15-2941 Email: lugi@de.ibm.com
Notices
97
To Next Page
Loading...
Need help?
General
