Reference Code Description/Action Perform all actions before exchanging Failing Items Failing Item
9101 Fibre Channel interface error detected
If the attached device is an external device, do the following before
exchanging any parts:
1. Ensure that the Fibre Channel cable is correctly connected to the ports.
2. Clean the Fibre Channel connectors.
3. If there is a hub attached, verify that the hub is operational.
4. If there is a gateway device attached, refer to the gateway device
service documentation for additional problem analysis procedures.
5. refer to the tape device service documentation for additonal problem
analysis procedures.
FCIOA
FCDEV
FCCABLE
9102 Gateway device detected a SCSI interface error
Use the gateway device service documentation to analyze the problem.
FI00871
FCGATE
FI00872
DEVTERM
9200 I/O processor addressed the tape unit; no response
If the attached device is an external device, do the following before
exchanging any parts:
1. Ensure that the device is powered on.
2. If an interposer is required, make sure that it is connected between the
I/O processor and the SCSI cable.
3. Ensure that the SCSI cable is seated correctly, and that there are no bent
or damaged pins on the SCSI cable.
4. Ensure that a terminating plug is attached to the device end of the SCSI
cable.
FI00871
FI01112
FI00872
DEVTERM
9201 Tape unit command timeout
If the attached device is an external device, do the following before
exchanging any parts:
1. Ensure that the device is powered on.
2. If an interposer is required, make sure that it is connected between the
I/O processor and the SCSI cable.
3. Ensure that the SCSI cable is seated correctly, and that there are no bent
or damaged pins on the SCSI cable.
4. Ensure that a terminating plug is attached to the device end of the SCSI
cable.
FI00871
FI01112
FI00872
DEVTERM
MH7TMED
9202 Tape unit failed after Licensed Internal Code was loaded
If the attached device is an external device, do the following before
exchanging any parts:
1. Ensure that the device is powered on.
2. If an interposer is required, make sure that it is connected between the
I/O processor and the SCSI cable.
3. Ensure that the SCSI cable is seated correctly, and that there are no bent
or damaged pins on the SCSI cable.
4. Ensure that a terminating plug is attached to the device end of the SCSI
cable.
FI00871
FI01112
FI00872
DEVTERM
9210 Illegal or unsupported tape unit response FI00871
FI01112
FI00130
63A0
178
iSeries: iSeries 270, 800, 810, 820, 825, 830, 840, 870, 890, SB2, and SB3 Analyze Hardware Problems (System Reference
Codes)
To Next Page
Loading...
Need help?
General