2. Move the upper CMA to the left to swing it out of the way.
a. To reattach the upper CMA to the rail, reverse the procedure.
3. To release the lower CMA, push the latch on the support rail connector ▌11▐ to
release it from the connector base ▌12▐ on the left rail.
4. Move the lower CMA to the right to swing it out of the way.
a. To reattach the lower CMA to the rail, reverse the procedure.
Installing or replacing the cable-management arm: 2077-92F
Use these procedures to install the cable-management arm (CMA) for the 2077-92F
expansion enclosure. You can also use these procedures to replace a faulty CMA
assembly.
About this task
As part of the initial installation of the 2077-92F expansion enclosure, you must
attach the CMA. You might also need to replace a faulty CMA with a new one
from FRU stock.
The cable management arm (CMA) consists of an upper arm and a lower arm
assembly, as Figure 49 on page 67 shows.
Figure 47. Release the upper CMA assembly
Figure 48. Release the lower CMA assembly
66 Storwize V5000 Gen2: Quick Installation Guide
To Next Page
Loading...
Need help?
General