v Query power-supply input power.
v ROM-based IMM firmware flash updates.
v Serial over LAN (SOL).
v Serial port redirection over telnet or ssh.
v SMI handling
v System event log (SEL) - user readable event log.
The IMM also provides the following remote server management capabilities
through the OSA SMBridge management utility program:
v Command-line interface (IPMI Shell)
The command-line interface provides direct access to server management
functions through the IPMI 2.0 protocol. Use the command-line interface to issue
commands to control the server power, view system information, and identify
the server. You can also save one or more commands as a text file and run the
file as a script.
v Serial over LAN
Establish a Serial over LAN (SOL) connection to manage servers from a remote
location. You can remotely view and change the UEFI settings, restart the server,
identify the server, and perform other management functions. Any standard
Telnet client application can access the SOL connection.
For more information about IMM, see the Integrated Management Module User's
Guide at http://www.ibm.com/systems/support/supportsite.wss/
docdisplay?lndocid=MIGR-5079770&brandind=5000008.
Using the embedded hypervisor
The VMware ESXi embedded hypervisor software is available on the optional IBM
USB flash device with embedded hypervisor. The USB flash device can be installed
in the USB connector near PCI riser slot 1 on the system board. Hypervisor is
virtualization software that enables multiple operating systems to run on a host
system at the same time. The USB flash device is required to activate the
hypervisor functions.
84 System x3530 M4 Type 7160: Installation and Service Guide
To Next Page
Loading...
Need help?
General