Replacing the server top cover
To replace the server cover, complete the following steps:
1. Make sure that all cables, adapters, and other components are installed and
seated correctly and that you have not left loose tools or parts inside the server.
Also, make sure that all internal cables are correctly routed.
2. Align the cover over the server (toward the rear of the server) until the cover
edges slip into position over the chassis.
Important: Before you slide the cover forward, make sure that all the tabs on
the cover engage the chassis correctly. If all the tabs do not engage the chassis
correctly, it will be hard to remove the cover later.
Chapter 2. Installing optional devices 67
To Next Page
Loading...
Need help?
General