Removing the front video connector
To remove the front video connector, complete the following steps:
1. Read the safety information that begins on page Safety and “Installation
guidelines” on page 30.
2. Turn off the server (see “Turning off the server” on page 21) and all attached
peripheral devices. Disconnect all power cords; then, disconnect all external
cables as necessary to replace the device.
3. Remove the server cover (see “Removing the server top cover” on page 362).
4. On a 3.5-inch server model, remove the front bezel (see “Removing the bezel”
on page 364).
5. Loosen the screws that secure the video connector to the front of the chassis.
6. Disconnect the video cable from the connector on the system board and
disengage the video cable from any cable clips on the chassis.
7. Remove the video connector and cable from the server.
8. If you are instructed to return the video connector, follow all packaging
instructions, and use any packaging materials for shipping that are supplied to
you.
Chapter 6. Removing and replacing components 339
To Next Page
Loading...
Need help?
General