6. From the front of the server, carefully pull the assembly out of the server.
7. If you are instructed to return the operator information panel assembly, follow
all packaging instructions, and use any packaging materials for shipping that
are supplied to you.
Replacing the operator information panel assembly
To install the operator information panel, complete the following steps.
1. Read the safety information that begins on page Safety and “Installation
guidelines” on page 30.
2. From the front of the server, slide the operator information panel into the
server until it stops.
3. Connect the signal cable to the rear of the operator information panel; then,
connect the other end of the signal cable to the connectors on the system board.
Route the signal cable as shown in the following illustration. Secure the cable
with any cable clips on the chassis.
Chapter 6. Removing and replacing components 331
To Next Page
Need help?
General