IBM System x3550 M3 Type 4254 Problem Determination And Service Guide

4. Replace the cover (see “Installing the cover” on page 174).
5. Slide the server into the rack.
6. Reconnect the power cord and any cables that you removed.
7. Turn on the peripheral devices and the server.
Removing the optional two-port Ethernet adapter
To remove the Ethernet adapter, complete the following steps:
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 167.
2. Turn off the server and peripheral devices and disconnect all power cords; then,
remove the cover (see “Removing the cover” on page 174).
3. Remove the PCI riser-card assembly (if installed) from PCI riser connector 1
(see “Removing a PCI riser-card assembly” on page 233.
4. Grasp the Ethernet adapter and disengage it from the standoffs and the
connector on the system board; then, slide the Ethernet adapter out of the port
openings on the rear of the chassis and remove it from the server.
Chapter 5. Removing and replacing server components 217

IBM System x3550 M3 Type 4254 Specifications

General

Brand	IBM
Model	System x3550 M3 Type 4254
Category	Server
Language	English