To Next Page

To Previous Page

Bezel

3. Reinstall the video connector screws.

4. Reinstall the hard disk drives and drive bay filler panels into the drive bays.

5. Install the cover (see “Installing the cover” on page 174).

6. Reconnect the power cords and any cables that you removed.

7. Slide the server into the rack.

8. Turn on the peripheral devices and the server.

Removing an optional optical drive cage

To remove an optional optical drive cage, complete the following steps:

1. Read the safety information that begins on page vii and the “Installation

guidelines” on page 167.

2. Turn off the server and peripheral devices and disconnect the power cords and

all external cables.

3. Remove the cover (see “Removing the cover” on page 174).

4. Remove the DVD cable (see “Removing the DVD cable” on page 229).

5. Remove the DVD drive (see “Removing an optional DVD drive” on page 189).

6. Remove the bezel (see “Removing the bezel” on page 227).

7. Slide the optional optical drive cage out of the chassis and set it aside.

Bezel

Optical drive cage

Installing an optional optical drive cage

The IBM System x3550 M3 DVD enablement kit is used to install an optical drive

cage in a server with less than four hard disk drives. The optional optical drive cage

is installed in the bays for hot-swap hard disk drives 5 to 8.

The DVD enablement option kit contains the following components:

v One optical drive cage

228 IBM System x3550 M3 Types 4254 and 7944: Problem Determination and Service Guide

IBM System x3550 M3 Type 4254 Problem Determination And Service Guide

Other manuals for IBM System x3550 M3 Type 4254