IBM ThinkPad 760ED Instruction Manual

Installing OS/2 Software
760
CD
If you are using a 760ED and installing the CD-ROM
version of OS/2 Warp using the CD-ROM drive, select one
of the following according to your configuration:
– To use the CD-ROM drive and an externally attached
diskette drive, go to page 172.
– To use the CD-ROM drive and the internal diskette drive
by switching between them, go to page 173.
Important
You need at least 90MB of free space on the hard
disk drive.
Installing OS/2 Warp with the Boot Manager
1 Install the Boot Manager, referring to the OS/2 Warp
documentation.
To install the DOS ThinkPad
Features program:
Page 187.
To install the Windows ThinkPad
Features program:
Page 194.
2 Install DOS and Windows, and the ThinkPad Features
programs for both DOS and Windows.
3 Install OS/2 Warp:
If you are installing the diskette version, refer to the OS/2
documentation; however, pay attention to the following:
– Select VGA as the Primary Display at the System
Configuration screen.
– Select No Support Installed, not System
Configuration, at the System Configuration screen.
–
760
CD
Select Non-Listed IDE CD-ROM for the
CD-ROM at the System Configuration screen.
After OS/2 has been successfully installed, make sure you
restart the computer.
Note:
If you have the OS/2 Warp FixPak
10 (XR0010) or later, install it after
you complete the installation of OS/2
Warp. Follow the instructions in the
README.1ST file in diskette 1 of
that FixPak.
Chapter 7. Installing Software 171

IBM ThinkPad 760ED Specifications

General

Brand	IBM
Model	ThinkPad 760ED
Category	Laptop
Language	English