IBM ThinkPad 760ED Instruction Manual

Using Easy-Setup
Using Easy-Setup
The computer has a built-in system setup function called
Easy-Setup .
Easy-Setup has the following menu:
Config shows information about installed memory and system
board.
Date/Time is used to set the current date and time.
To set passwords:
Page 102.
Password is used to set the power-on password, hard disk
password, and supervisor password.
To change the startup sequence:
Page 38.
Start up is used to change the startup sequence of your
computer.
To test the computer:
Page 233.
Test is used to test the computer hardware.
Restart is used to exit Easy-Setup and start your operating
system.
To start Easy-Setup:
1 Turn off the computer, and remove any diskette from the
diskette drive.
Note:
You can change the screen color of
the
Easy-Setup menu with the key
combinations of Ctrl+PgUp or
Ctrl+PgDn. Use Ctrl+Home to
restore the original screen color.
2 Press and hold F1; then turn on the computer. Hold F1 until
the
Easy-Setup menu appears.
Date/Time Password
Easy-Setup
Start up
Te st
Restart
Config
BIOS part number,..Date
System-unit serial number
System board serial number
Microprocessor
nnnnnnnnnnnnnnnn
nnnnnnnnnnn
Pentium( )Process
**
nnnnnnn
12/31/96
Chapter 3. Operating Your Computer 37

IBM ThinkPad 760ED Specifications

General

Brand	IBM
Model	ThinkPad 760ED
Category	Laptop
Language	English