4. Connect the cables from the power-supply cage to the system board and all
internal components (see “System-board internal connectors” on page 30 for the
locations of the internal connectors). Rotate the hard disk drive cage out of the
chassis to insert the power cable to the backplane.
Cable clip
Figure 216. Power cable insertion to the backplane for 5U server model with hot-swap power
supplies (1)
Power cable connector
Power interposer
cable connector
Figure 217. Power cable insertion to the backplane for 5U server model with hot-swap power
supplies (2)
Chapter 6. Removing and replacing components 299
To Next Page
Loading...
Need help?
General