v Drive 0 indicates hard disk drive 0.
v Drive 1 indicates hard disk drive 1.
v Drive 2 indicates hard disk drive 2.
v Drive 3 indicates hard disk drive 3.
2. In MegaRAID Storage Manager utility:
v Slot 0 indicates hard disk drive 0.
v Slot 1 indicates hard disk drive 1.
v Slot 2 indicates hard disk drive 2.
v Slot 3 indicates hard disk drive 3.
Attention: Simple-swap hard disk drives are not hot-swappable. Disconnect all
power from the server before you remove or install a simple-swap hard disk drive
Note: If you installed a ServeRAID adapter in the server, connect the other end of
the SATA signal cable to the connector on the ServeRAID adapter.
To install a simple-swap SATA hard disk drive on 4U server models with
non-hot-swap power supplies, complete the following steps.
1. Read the safety information in “Safety” on page vii and “Installation
guidelines” on page 35.
2. Turn off the server and peripheral devices and disconnect all external cables
and power cords.
3. Remove the bezel (see “Removing the bezel” on page 40).
4. Touch the static-protective package that contains the drive to any unpainted
metal surface on the server; then, remove the drive from the package and place
it on a static-protective surface.
5. Align the drive assembly with the guide rails in the bay (the connector end of
the drive goes in first).
6. Grasp the black drive handle and slide the blue release latch to the right; then,
carefully slide the drive assembly into the drive bay until it stops, and release
the latch.
Chapter 2. Installing optional devices 59
To Next Page
Need help?
General
