8
1
PANEL DESCRIPTION
New2001
1
PANEL DESCRIPTION
The following functions can be set to [F-1] and [F-2] to use during receive or in stand-by, or during transmit. (p. 14)
During RX/Standby:
Function Description
--- No function
MONI
([F2] key: Default)
Push to open or close the squelch.
MR000
In the Memory mode, push to select Memo-
ry channel 000.
MR001
In the Memory mode, push to select Memo-
ry channel 001.
BND.BNK
([F1] key: Default)
In the VFO mode, push to select an operat-
ing band.
In the Memory mode, push to select Bank
A to J, or OFF.
•Onlytheprogrammedbankappears.
SCAN Push to start or stop a scan.
T-SKIP
Push to set the frequency to be skipped dur-
ing scanning.
The selected frequencies are temporarily
skipped for faster scanning.
MODE Push to change the operating mode.
LOW Push to change the transmit power level.
DUP
Push to turn the Duplex mode ON or OFF,
and the shift direction to DUP+ or DUP–.
PRIO
Push to turn the Priority watch ON or OFF.
TONE Push to toggle between tone types.
Function Description
MW
In the VFO mode, hold down for 1 second
to save the frequency displayed in the MAIN
band into a Memory channel.
•Thefrequencyisautomaticallysavedinablank
channel.
MUTE Push to turn the Mute function ON or OFF.
DTMFTX
Push to display the DTMF code direct entry
mode screen.
T-CALL Push to transmit a 1750 Hz tone.
During TX:
Function Description
---
([F2] key: Default)
No function
LOW Push to change the transmit power level.
T-CALL
([F1] key: Default)
Push to transmit a 1750 Hz tone.
To Next Page
Loading...
Need help?
General
