31
4
MEMORY OPERATION
New2001 New2001
D Copying Memory content to the VFO
This is convenient when you want to change the frequency
beginning near the Memory or Call channel frequency.
Select a desired Memory channel to be copied. (p. 29) q
Push [MW] w C to display the Memory entry screen.
Rotate [DIAL] e
S to select “TO VFO.”
Push [ r ï]D.
•Beepssound.
•WritestheselectedMemorycontenttotheVFO,andreturnsto
the VFO mode.
D Copying Memory content to another
Memory channel
You can copy the memory content to another Memory chan-
nel.
Select the desired Memory channel to be copied. (p. 29) q
Push [MW] w C to display the Memory entry screen.
Rotate [DIAL] e
S to select “COPY.”
Push [ r ï]D.
Rotate [DIAL] t
S to select a target channel.
•Ifyouselectapre-enteredchannel,thepreviouschannelcon-
tent is displayed.
Select
Push [ y ï]D.
•Beepssound.
•Copiestothedestinationchannel.
•Whenyouselectapre-enteredchannel,“OVERW?”isdisplayed.
Rotate [DIAL]S to select “YES,” and then push [ï]D to over-
write it.
The C, S, or D in the
instructions indicate the
area of the controller.
C: Center
S: Side
D: Display
Writing into a Memory or Call channel (Continued) ■
To Next Page
Loading...
Need help?
General
