6
40
MEMORY OPERATION
n Memory channels
The IC-910H has 106 memory channels (99 for regu-
lar, 6 scan edges and 1 call) and they are equipped for
each frequency band for storing the most often used
frequencies and operating mode, as well as tone fre-
quency, offset frequency, etc.
n Operation on a memory
channel
Frequency and mode, etc., can be changed in a mem-
ory channel. However, they will be cleared if [MW 4] is
not pushed.
D Memory channel selection
q Push [V/M 1] to select memory channel mode.
•“MEMO”indicatorappears.
w Push [DN Z] or [Y UP] to select the desired mem-
ory channel.
•Memorychannelchangescontinuouslywhileholding
[DN Z] or [Y UP].
•Thetuningdialrotationwhilepushing[F-INPENT]also
selects memory channel.
e Push [V/M 1] to return to VFO mode.
D During VFO mode operation
By pushing [DN Z] or [Y UP] during VFO mode op-
eration, memory channel is also selectable. However,
the frequency readout does not change in this case,
only the memory channel number changes.
Memory
Channel
1–99
1A/1b–3A/3b
C
Description
Regular memory channels. Programs
operating frequency, mode, subaudible
tone activity with frequency and split/du-
plex conditions.
Scan edge channels. Programs edge fre-
quencies for programmed scan.
Call channel recalls a specified frequen-
cy on the instant. Programs operating
frequency, mode, etc., and is available
for each band, independently.
To Next Page
Loading...
Need help?
General
