Icom IC-910H User Manual

12
2
PANEL DESCRIPTION
n Rear panel
q 430(440) MHz ANTENNA CONNECTOR (p. 15)
Accepts a 50 Ω antenna with a type-N connector.
w DC POWER SOCKET [DC 13.8V] (p. 17)
Accepts 13.8 V DC through the supplied DC power
cable (OPC-657A).
Rear panel
view
+_
e 144 MHz ANTENNA CONNECTOR (p. 15)
Accept a 50 Ω antenna with a PL-259 connector.
r SUB BAND EXTERNAL SPEAKER JACK
[SP (SUB)]
t MAIN BAND EXTERNAL SPEAKER JACK
[SP (MAIN)] (p. 16)
Accepts a 4–8 Ω speaker.
By connecting an external speaker for each or both
jacks, the audio for both the MAIN and SUB bands
is output as follows.
y 1200 MHz ANTENNA CONNECTOR (p. 15)
Available when the optional 1200 MHz band unit
is installed. Accepts a 50 Ω antenna with a type-N
connector.
u KEY JACK [KEY] (p. 15)
Accepts a paddle, a straight key or external elec-
tronic keyer with
1
⁄8 inch standard plug.
(+)
(_)
(dot)
(com)
(dash)
i SUB BAND DATA SOCKET [DATA (SUB)]
o MAIN BAND DATA SOCKET [DATA (MAIN)]
(p. 13)
6-pin mini plug DIN jack to connect a TNC, etc. for
high speed data communications.
Independent data sockets enable simultaneous re-
ception in both MAIN and SUB bands for data com-
munication.
 (MAINband:TX/RX,SUBband:RXonly)
!0 ACCESSORY SOCKET [ACC(1)]
Enables connection of external equipment such as
a TNC for data communications, etc.
 •Seetherighttableforsocketinformation.
!1 CI-V REMOTE CONTROL JACK [REMOTE]
(p. 78)
Designed for use with a personal computer via the
optional CT-17 for remote control of transceiver
functions.
!2 GROUND TERMINAL [GND] (p 14)
Connect this terminal to a ground to prevent electri-
cal shocks and other problems.
o
!2
w
e
rt
y
u
i
q
!0
!1
MAIN AF SUB AF
No Int. SP Int. SP
SP (MAIN) Ext. SP Ext. SP
SP (SUB) Int. SP Ext. SP
Both Ext. SP (MAIN) Ext. SP (SUB)

Icom IC-910H Specifications

General

Brand	Icom
Model	IC-910H
Category	Transceiver
Language	English