Icom IC-9700 Service Manual

4-4
4-2 FRONT PANEL OPERATION VERIFICATION
1. Touch [FRONT] on the main adjustment menu screen.
2. Touch [KEYch] to enter to the key operation verification mode.
3. Follow the instructions displayed on the screen, and push the corresponding key.
4. Follow the instructions displayed on the screen, and turn the corresponding dial and sensor.
5. Follow the instructions displayed on the screen, and insert/remove the SD card.
6. Follow the instruction displayed on the screen, and verify the corresponding LED is lit.
7. Push the [TONE (RX→CS)] key, and verify the LCD screen changes in order of red, green, blue, minimum, and
maximum backlight brightness.
8. Push the [TONE (RX→CS)] key to start the touch screen calibration, and touch the dot in order of the instructions
displayed on the screen.
9. Push [EXIT] to return to the main adjustment menu screen.
www.PH4X.com

Icom IC-9700 Specifications

General

Brand	Icom
Model	IC-9700
Category	Transceiver
Language	English