19. Changing a Partition
Hold down the [MODE] key until the beep,
then enter [1] [*] [Partition Number] [*]
To change partitions the keypad must be a global keypad.
1. Ensure that the Panel is disarmed
2. Hold [MODE] until the keypad beeps.
3. Press [1] [*] followed by the [Partition Number] [*].
If no key is pressed on the keypad for specified delay period (default is 20 seconds), the keypad will
beep and default back to its original partition. The keypads may be programmed to remain in the new
partition. (Ask your Installer about this option). Entering partition numbers other than those in the range 1
to 8 will produce a key entry error.
20. Output Control via a Keypad
If the panel has been set up to control switching functions via its outputs, these can be controlled via the
keypad - e.g. turning lights on and off.
Hold down the [MODE] key and press [3] [*].
(Any outputs that are currently set [ON] will be shown as an on zone indicator.)
To toggle the output status, enter [OUTPUT NUMBER] followed by [*]. Press [#] to exit User Program
Mode.
Ensure that you have checked with your installer which outputs are used for radio reporting so
as to prevent the triggering of false alarms.
To Next Page
Loading...
Need help?
General
